Single-row deep groove ball bearing
It is the most commonly used radial ball bearing which consists of inner ring, outer ring, ball, retainer and shield.
Deep groove ball bearing with flanged outer ring
It is a deep groove ball bearing with a flange on one side of the outer ring. It is easy to install at the time of assembly if this bearing is used,.
Deep groove ball bearing with extended inner ring
It is an inch type deep groove ball bearing in which the inner ring width is expanded to both sides from the outer ring width. Using this bearing simplifies the design and assembly around the bearings.
Extra-thin-section deep groove ball bearing
It is a deep groove ball bearing whose ratio of the outer diameter to the inner diameter is smaller than the standard. By using this bearing, it is possible to reduce the size and weight of the equipment.
Thrust ball bearing
It consists of a flat bearing washer without a raceway and a retainer assembled with balls. It can load only axial load in one direction.
Thrust ball bearing with groove
Compared with thrust ball bearings, higher load ratings were secured by attaching raceway to the upper and lower bearing washers.
Pivot ball bearing
It consists of an outer ring and several balls and supports a conical section (usually 60° pivot) at the tip of the rotating shaft.
Angular contact ball bearing
A miniature thrust angular contact ball bearing suitable for applications where a high axial load acts.
Casstop bearing
High anti-corrosion bearing using newly developed highly anti-corrosion martensitic stainless steel TBN - 6H. Innovative corrosion resistance, and a load-bearing performance
Please specify the bearing type and size range (minimum value to maximum value) of the product to be searched.
- Click the line you want to download and click the "Download" button.
- If the CAD file name does not exist, please note that even if you press the button, it will not be downloaded.
- If an error occurs during download, there may be a cause in the transmission environment.
{{alertMsg}}
{{msgMsg}}
Note
- Dimensions are mm.
- 0 or - an item that is displayed is the item that data does not exist.
- The value displayed in - (minus) does not conform to JIS B 1521.
Note
- When using shielded bearings with outer ring rotation, please contact with ISC.
- For bearings where both shield type (ZZ, ZZ1) are listed, single shield bearings are also manufactured.
- We also produce bearings with snap ring, so please contact with ISC.
Request when using CAD data
If you use (replicating) CAD data, we understand that you have accepted the following conditions.- The copyright of NSK Micro Precision Co.,Ltd. is existing in CAD Data.
Copying and transffering of CAD data are limited with following conditions
1) Copying of CAD data is allowed only back up purpose.
2) Transferring of CAD data to 3rd party is allowed only in case NSK Micro Precision CO., Ltd agrees.
- You should take responsible for CAD data selection, use and its results.
- Modification of CAD data is prohibited in principle. If any change is made, it is your responsibility for the result of using it.
Contact about CAD data
6F Hirose Bldg., 3-17 Kanda-nishiki cho, Chiyoda-ku, Tokyo 101-0054NSK Micro Precision Co., LTD.
Sales department customer support
TEL:03-5283-7420 FAX:03-5259-0882
E-Mail：contact1@nskmicro.co.jp
URL：https://www.nskmicro.co.jp
System Version 3.4.0.0